- Notes, cautions, and warnings
- Working on your computer
- Major components of your system
- Technology and components
- Disassembly and reassembly
- System setup
- Troubleshooting
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Power-Supply Unit Built-in Self-Test
- Real-Time Clock (RTC Reset)
- System diagnostic lights
- Diagnostic error messages
- System error messages
- Recovering the operating system
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
Vostro 3681 Service Manual
Installing the power button
Prerequisites
About this task
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
Steps
- Slide the power-button cable through the slot on the front of the chassis.
- Align the tabs on the side of the power button with the cut outs on the slot in the chassis.
- While pressing the release tabs on the power button, insert it through the slot on the chassis, and then secure it into place.
- Connect the power-button cable to the system board.
Next steps
- Install the HDD/ODD Bracket.
- Install the front bezel.
- Install the side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\