Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

getniccfg

Table 1. getniccfgThe following table contains the description, synopsis, and input of the getniccfg command.
Description	Displays the current NIC settings.
Synopsis	racadm getniccfg
Input	racadm getniccfg racadm getniccfg –m <module> where –m must be one of the following values: chassis : default state if -m is not specified server-n : where n = 1 to 4 switch-n : where n = 1
Example	racadm getniccfg NIC Enabled = 1 IPv4 Enabled = 1 DHCP Enabled = 1 Static IP Address = 192.168.0.120 Static Subnet Mask = 255.255.255.0 Static Gateway = 192.168.0.1 Current IP Address = 10.94.225.212 Current Subnet Mask = 255.255.255.128 Current Gateway = 10.94.225.129 IPv6 Enabled = 0 Autoconfiguration Enabled = 1 Static IPv6 Address = ::/64 Static IPv6 Gateway = :: Link Local Address = :: Current IPv6 Address 1 = :: Current IPv6 Gateway = :: Speed = Autonegotiate Duplex = Autonegotiate VLAN Enable = 0 VLAN ID = 1 VLAN priority = 0 racadm getniccfg -m server-3 LOM Model Name = BRCM GbE 4P 5720 bNDC LOM Fabric Type = Gigabit Ethernet IPv4 Enabled = 1 DHCP Enabled = 0 IP Address = 0.0.0.0 Subnet Mask = 0.0.0.0 Gateway = 0.0.0.0 IPv6 Enabled = 0 Autoconfiguration Enabled = 1 Link local Address = IPv6 Gateway = :: VLAN Enable = 0 VLAN ID = 1 VLAN priority = 0 racadm getniccfg -m switch-1 DHCP Enabled = 0 IP Address = 0.0.0.0 Subnet Mask = 0.0.0.0 Gateway = 0.0.0.0