Installing the 2.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 2.5-inch hard-drive assembly and provides a visual representation of the installation procedure.
Steps
NOTE: Note the orientation or the SATA connector marking on the hard drive to replace it correctly.
Place the hard drive into the hard-drive carrier
and align the tabs on the carrier with the slots on the hard drive.- Slide the hard-drive assembly into the hard-drive
cage until it snaps into place.
- Connect the data cable and power cable to
the hard drive.
Data is not available for the Topic