Installing the 3.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard-drive assembly and provides a visual representation of the installation procedure.
Steps
- Slide the hard drive into the hard-drive cage.
- Replace the four screws (#6-32) that secure the hard drive to the hard-drive cage.
- Align the hard-drive assembly with the tabs on the chassis.
- Using the alignment post, align the screw hole on the hard-drive assembly with the screw hole on the chassis.
- Route the power cable and data cable through the routing guides on the hard-drive assembly and connect the cables to the hard drive.
- Replace the screw (#6-32) that secures the hard-drive assembly to the chassis.
Data is not available for the Topic