To remove the
PCIe brackets (1 and 3) as shown below, insert a screwdriver in
the hole of a PCIe bracket and push hard to release the bracket [2],
and then lift the bracket out from your computer.
NOTE:To remove the PCIe brackets (2 and 4), push the bracket upwards from
the inside of your computer to release it and then lift the bracket
away from your computer.
Insert the PCIe expansion card to the connector on the system board.
Secure the PCIe expansion card by pushing the card retention
latch until it clicks into place.
NOTE:This step is applicable only for the connector with card retention latch, otherwise, skip this step.
Repeat the steps to install any additional PCIe expansion card.