Insert the WLAN card into the connector on the WLAN module.
Connect the WLAN antenna cables to the connectors on the WLAN card.
Place the WLAN card bracket
to secure the WLAN cables.
Tighten the screw to secure the WLAN card to the system.
Pull the release latch to open [1].
To remove the
PCIe brackets (1 and 3) as shown below, insert a screwdriver in
the hole of a bracket and push hard to release the bracket [2],
and then lift the bracket out from your computer.
NOTE:To remove the PCIe brackets (2 and 4), push the bracket upwards from
the inside of your computer to release it and then lift the bracket
away from your computer.
Insert the WLAN module into the connector on the system
board and press until it is secured.
NOTE:The WLAN module can be installed in PCIe slots 1 and 4 only.
Connect the WLAN module cable to the connector
on the system board.