OptiPlex 3050 Tower Owner's Manual

Removing intrusion switch

1. Follow the procedure in Before working inside your computer.
2. Remove the:
   1. cover
   2. bezel
3. Open the front panel door.
4. To remove the intrusion switch:
   1. Disconnect the intrusion switch cable from the connector on the system board [1].
   2. Unroute the intrusion switch cable from the fan grommet [2].
   3. Remove the adhesive tape that holds the intrusion switch cable on the system fan [3].
   4. Slide the intrusion switch and push it to remove from the computer [4].