The service system board jumper must be set
to PW_CLR to function normally. Jumper will be parked at " PW_CLR " for both
production and service motherboard by the default. The issue of
cycling reboot will occurred if the technician or customers did not
place the jumper back to " PW_CLR " after clearing CMOS.
Table 1. System board jumper detailsSystem board jumper details
SERVICE_MODE
1-2 Short: Disable
1-2 Open: Default
CMOS_CLR
3-4 Short: CMOS Clear
3-4 Open: Default
PW_CLR
5-6 Short: Default
5-6 Open: Password: Reset
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\