The hard drive
or SSD (Solid-State Drives) indicators display different patterns
as drive events occur in the system.
NOTE: The sled must have a hard drive
or SSD or a hard drive blank installed in each drive bay.
Figure 1. Hard drive or
SSD indicators
drive activity indicator (green)
drive status indicator (green and amber)
NOTE: If the drive
is in Advanced Host Controller Interface (AHCI) mode, the status LED
(on the right side) does not function and remains off.
Drive-Status Indicator Pattern
Condition
Flashes green twice per second
Identifying drive or preparing for
removal
Off
Drive ready for insertion or removal
NOTE: The drive status
indicator remains off until all drives are initialized after system
power is applied. Drives are not ready for insertion or removal during
this time.
Flashes green, amber, and then turns off
Drive predicted failure
Flashes amber four times per second
Drive failed
Flashes green slowly
Drive rebuilding
Steady green
Drive online
Flashes green for three seconds, amber for three seconds,
and turns off after six seconds
Rebuild stopped
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
