Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge FC630 Owner's Manual

PDF

Removing the hard drive or SSD backplane

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

  1. Follow the safety guidelines listed in safety instructions section..

  2. Keep the Phillips #2 screwdriver ready.

  3. Follow the procedure listed in Before working inside your system section.

    CAUTION: To prevent damage to the hard drives or SSDs and the hard drive or SSD backplane, you must remove the hard drives or SSDs from the sled before removing the hard drive or SSD backplane.
    CAUTION: You must note the number of each hard drive or SSD and temporarily label them before removal so that you can replace them in the same locations.

  4. Remove the hard drive(s) or SSD(s).

  1. Loosen the two retention screws securing the hard drive or SSD backplane to the hard drive or SSD cage.
  2. Lift the hard drive or SSD backplane by its edges till the guide pin on the hard drive or SSD cage disengages with the guide on the hard drive or SSD backplane.
  3. Remove the hard drive or SSD cage. See the Removing the hard drive or SSD Cage section.
  4. Loosen the two retention screws securing the hard drive or SSD backplane cable connector to the system board connector.
  5. Lift the backplane up and away from the system.
    Figure 1. Removing the hard drive or SSD backplane
    This figure shows removing a hard drive or SSD backplane.
    1. hard drive or SSD backplane
    2. hard drive or SSD backplane cable
    3. retention screw (2)
    4. screw hole on the hard drive or SSD cage (2)
    5. guide pin
    6. retention screw on the hard drive or SSD backplane cable connector (2)
    7. connector

  1. Install the hard drive or SSD backplane, see the Installing the hard drive backplane section.

  2. Install the hard drive or SSD.

  3. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\