Advanced Driver Restore for Windows Reinstallation
To download and install system's device driver installation of a newly installed operating system follows the steps:
On the
Welcome screen,
click here to download and install a complete driver library.
NOTE: The process of downloading the driver library for the system is automated.
NOTE: This process might even cost you, if you are on a metered network connection.
The
Preparing for driver restore screen is displayed, and the drivers are installed. Following are the various status messages that are displayed during installation:
Checking for component updates.
Scanning system devices—Scans the system and gathers the system information.
Locating system driver library—Determines the system driver library to be downloaded.
Starting download—Starts downloading the driver library.
Extracting drivers—After the systems driver library is downloaded, these drivers are extracted for installation on the system.
Preparing for installation—Digital signature validation and creation of a restore point on the operating system.
Installing drivers—Displays the installation status in the format x of y, where ‘x’ is the number of drivers being installed and ‘y’ is the total number of drivers available. Select the
Automatically restart system (when required) check box to restart the system automatically after the drivers are installed.
Installation complete—Displays the driver installation result in the format x of y successful, where ‘x’ is the number of drivers that are installed and ‘y’ is the number of drivers available.
Click
CANCEL to exit this activity and return to the
Welcome screen.
After installation of the drivers is complete, click
CLOSE to return to the
Welcome screen.
For more information about updating the system drivers to their most current version, see
Install updatessection.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\