iDRAC 8/7 v2.70.70.70 RACADM CLI Guide

To run this subcommand, you must have Configure iDRAC privilege.

NOTE: : An error message is displayed when the following is performed:

• A set operation is performed on an unsupported FQDD.

• Out of range settings is entered.

• Invalid sensor FQDD is entered.

• Invalid threshold level filter is entered.

racadm sensorsettings set <FQDD> -level Min <value>

• <FQDD> — Sensor or corresponding sensor FQDD which needs a threshold configuration. Run the command, racadm getsensorinfo to view the sensor FQDD. The R/W field in the output getsensorinfo indicates if the sensor thresholds can be configured. Replace the <FQDD> field with the corresponding sensor FQDD that needs a threshold configuration.
• -level — threshold level for the sensor setting. Values are Max or Min.

racadm sensorsettings set iDRAC.Embedded.1#SystemBoardCPUUsage -level Max 95

NOTE: : The entered value must be lesser or higher than the sensor critical threshold limit.