Skip to main content

Dell PowerVault ME4 Series Storage System CLI Guide

PDF

show replication-sets


Description	Shows information about replication sets in the peer connection. This command applies to virtual storage only. You can view information about all replication sets or a specific replication set. For virtual storage, you can run this command on either the primary or secondary system. In console mode, this command does not show the serial numbers of items such as replication volumes. To see serial numbers, run this command in API mode. Timestamps use the local time zone of the system on which this command is run. NOTE:If you change the time zone of the secondary system in a replication set whose primary and secondary systems are in different time zones, you must restart the system to enable management interfaces to show proper time values for replication operations. Properties shown only in API output are described in API basetypes properties
Minimum role	monitor
Syntax	show replication-sets [`replication-set-ID`]
Parameters	replication-set-ID Optional. The name or serial number of a replication set for which to display information at the replication set level. A name that includes a space must be enclosed in double quotes. If this parameter is omitted, information is shown for all replication sets.
Output	Overview information: Name The replication set name. Group Yes: The replication set is part of a group. No: The replication set is not part of a group. Primary Location The location of the primary volume in the replication set: Local or Remote. Peer The name of the peer connection. Primary Volume The primary volume name. If it is a volume group, it uses the .* notation. Secondary Volume The secondary volume name. If it is a volume group, it uses the .* notation Policy The action to take when a replication is running and a new replication is requested. discard: Discard the new replication request. queue-latest: Take a snapshot of the primary volume and queue the new replication request. If the queue contained an older replication request, discard that older request. A maximum of one replication can be queued. Queue Count The number of queued replications for the replication set: either 0 or 1. Status Not Ready: The replication set is not ready for replications because the system is still preparing the replication set. Unsynchronized: The primary and secondary volumes are unsynchronized because the system has prepared the replication set, but the initial replication has not run. Running: A replication is in progress. Ready: The replication set is ready for a replication. Suspended: Replications have been suspended. Unknown: This system cannot communicate with the primary system and thus cannot be sure of the current state of the replication set. Check the state of the primary system. Last Successful Run The date and time when the system took a snapshot of the primary volume in preparation for starting the last successful replication run. The value shows when the primary and secondary volumes were last known to be in sync. Last Status The status of the last attempted replication. Last run or current run information: Replication Last Run or Current Run. Progress The percentage complete for an active replication. Otherwise, N/A. Data Transferred The total number of bytes transferred. Start Time The date and time when the replication started. End Time For the last run, the date and time when the replication ended. Estimated Completion Time For the current run, the date and time when the replication is estimated to end. Run Error A message that says whether the replication succeeded or an error occurred.
Examples	Show information about all replication sets. # show replication-sets Show information about replication set RS1. # show replication-sets RS1
Basetypes	cs-replication cs-replication-set status
See also	create replication-set delete replication-set resume replication-set set replication-set suspend replication-set