Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware m17 R3 Service Manual

Removing the keyboard

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the 2230 solid-state drive in M.2 slot one, if installed.
  4. Remove the 2280 solid-state drive in M.2 slot one, if installed.
  5. Remove the 2230 solid-state drive in M.2 slot two, if installed.
  6. Remove the 2280 solid-state drive in M.2 slot two, if installed.
  7. Remove the rear I/O-cover.
  8. Remove the battery.
  9. Remove the right I/O-board.
  10. Follow step 1 to step 21 in removing the system board.

About this task

The following image indicates the location of the keyboard and provides a visual representation of the removal procedure.

Image: Removing the keyboard

Image: Removing the keyboard

Steps

  1. Open the latch, and disconnect the keyboard-backlight cable from the keyboard-controller board.
  2. Open the latch, and disconnect the keyboard cable from the keyboard-controller board.
  3. Remove the ten (M1.2x2.1) screws that secure the keyboard bracket to the keyboard.
  4. Lift the keyboard bracket off the keyboard.
  5. Remove the 28 (M1.2x1.6) screws that secure the keyboard to the palm-rest assembly.
  6. Lift the keyboard off the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\