Issue: Unable to use Dell Command | Configure after reinstallation/upgrade.
Description: Dell command | Configure may not work after reinstallation/upgrade on Ubuntu Desktop 16.04 because dcdbus module may not be loaded during reinstallation.insmod <filename>
Issue: Windows 7 does not recognize the digital signature validity.
Description: If the system is not connected to internet, Windows 7 does not recognize the digital signature validity of Dell Command | Configure installation file.Resolution: Connect the system to internet and validate the digital signature.
Issue: Dell Command | Configure supports only single-byte characters for asset set operation.
Resolution: If the user has a different locale, change the keyboard layout to English before using the asset option.Issue: TPM-related tokens can be modified independently.
Description: Dell Command | Configure does not control the dependencies among the various TPM PPI options. For example, it is possible to change the TPM PPI ACPI option through Dell Command | Configure even when TPM is not On.Issue: Dependent options are not working as configured in UEFI mode for Legacy Option ROM and Secure Boot
Description:Issue: Blinkpsu1led and Blinkpsu2led missing in the .ini file or SCE.
Description: Blinkpsu1led and Blinkpsu2led will not be present in the .ini file or SCE as they are enable-only tokens and they are active only for few seconds. These tokens cannot be modified using GUI.Issue: advsm option displays the status as Other
Description: If any of the fans is not working, the advsm option displays the status as Other.Issue: Advance Battery Charge and Peak Shift Charge options display Disable.
Description: Platforms that do not support Advance Battery Charge option, when advbatterychargecfg option is enumerated, the system displays the option as Disable.Platforms that do not support Peak Shift Charge option, when peakshiftcfg option is enumerated, the system displays the option as Disable.
Issue: Temperature probe in Advanced System Management option displays as Unknown.
Description: On some platforms that support Advanced System Management option, temperature probe of all the sensors displays as Unknown.Issue: A warning message is not displayed for BootOrder while enabling and disabling the same device.
Description: Dell Command Configure does not display any warning messages when you try to enable or disable the same bootable device.Example: cctk bootorder --bootlisttype=uefi --EnableDevice=hdd.1,hdd.2 --DisableDevice=hdd.1,hdd.2
Resolution: If the current status of the device is enabled, then the same device will be disabled or vice versa.