- Notes, cautions, and warnings
- Introduction to Dell Command | Configure 4.7
- Installing Dell Command | Configure 4.7 for systems running on Windows
- Installing Dell Command | Configure 4.7 for systems running on Linux
- Uninstalling Dell Command | Configure 4.7 for systems running on Windows
- Uninstalling Dell Command | Configure 4.7 for systems running on Linux
- Upgrading Dell Command | Configure 4.7 for systems running on Windows
- Upgrading Dell Command | Configure 4.7 for systems running on Linux
- Dell Command | Configure 4.7 for Windows Preinstallation Environment
- Creating a bootable image preinstallation environment using Windows PE 4.0, 5.0, and 10.0
- Creating a bootable image preinstallation environment using Windows PE 2.0 and 3.0
- References for Dell Command | Configure
Dell Command | Configure Version 4.7 Installation Guide
Upgrading Dell Command | Configure for systems running on Windows using a DUP
Perform the following steps to upgrade
Dell Command
| Configure (formerly Dell Client Configuration Toolkit) to the next version:
-
Double-click the downloaded DUP, and then click INSTALL.
The Dell Command | Configure installation wizard is launched.
- Run the installation wizard, and follow the instructions that are displayed on the screen.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\