Note the output from this command, as shown in the following example:
# Source Storage UID: 503
To determine if the account exists for this UID, log in to the
DD system in the
Cyber Recovery vault and run the following command:
# user show list
If the output lists the UID, you can proceed with the recovery procedure.
If the output does not show that the UID exists, go to the next step.
Create the UID:
When adding the application asset, if you defined a tag, reference the tag to determine the production system DD Boost username.
Create the username and account by running the following command:
# user add <NetWorker_ddboostname> uid <UID from user show list output>
For earlier versions, run the
user add command until you get the UID required for recovery. For example, if you have a UID 510, you might have to create up to nine
temp accounts. Note that
user add on the
DD system starts at UID 500.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\