Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Chassis Management Controller Version 2.0 for Dell PowerEdge VRTX User's Guide

PDF

Configuring SNMP Trap Alert Destinations Using CMC Web Interface

To configure IPv4 or IPv6 alert destination settings using CMC Web interface:
  1. In the left pane, click Chassis Overview > Alerts > Trap Settings .
  2. On the Chassis Event Alert Destinations page, type the following:
    • In the Destination field, type a valid IP address. Use the quad-dotted IPv4 format, standard IPv6 address notation, or FQDN. For example: 123.123.123.123 or 2001:db8:85a3::8a2e:370:7334 or dell.com.

      Choose a format that is consistent with the networking technology or infrastructure. The Test Trap functionality cannot detect incorrect choices based on the current network configuration (example, use of an IPv6 destination in an IPv4-only environment).

    • In the Community String field, enter a valid community name to which the destination management station belongs.

      This community string differs from the community string on the Chassis Overview > Network > Services page. The SNMP traps community string is the community that CMC uses for outbound traps destined to management stations. The community string on the Chassis Overview > Network > Services page is the community string that management stations use to query the SNMP daemon on CMC.

    • Under Enabled , select the option corresponding to the destination IP to enable the IP address to receive the traps. You can specify up to four IP addresses.
  3. Click Apply to save the settings.
  4. To test whether the IP address is receiving the SNMP traps, click Send in the Test SNMP Trap column.

    The IP alert destinations are configured.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\