Dell Command | Configure Version 3.0 Command Line Interface Reference Guide

• enable — The system wake-on-LAN feature is enabled; either an onboard or an add-in NIC can wake the system up.
• disable — The system does not respond to magic packets or other means of wake-on-LAN. The NIC chip section that looks for packets will not be powered.
• addincard — Enables NICs, plugged into the special power connector, as the source of any wake-on-LAN signal.
• onboard — The onboard NIC is enabled for wake-on-LAN.
• enablewakeonwlan — Enables wake-on-LAN for wireless.
• lanorwlan — On systems that have onboard LAN and wireless LAN hardware, enables wake on either wired or wireless LAN.
• lanwithpxeboot — Enables the network controller and causes the system to wake up and immediately boot to PXE when a wake packet is sent to the system in the S4 or S5 state.

C:\>cctk --wakeonlan=lanwithpxeboot
                                                      wakeonlan=lanwithpxeboot