- Notes, Cautions, and Warnings
- Introduction
- Accessing Command | Configure installer
- Installation prerequisites
- Installing Command | Configure on systems running Microsoft Windows
- Installing Command | Configure on systems running Linux
- Important information
- Uninstalling Command | Configure on systems running Microsoft Windows
- Uninstalling Command | Configure on systems running Linux
- Upgrading Command | Configure on systems running Microsoft Windows
- Upgrading Command | Configure on systems running Linux
- Command | Configure
for Microsoft Windows Preinstallation Environment (Windows PE)
- Creating a bootable image PE using Microsoft Windows PE 4.0 and 5.0
- Creating a bootable image PE using Microsoft Windows PE 2.0 And 3.0
- Reference
Dell Command | Configure Version 3.0 Installation Guide
Upgrading Command | Configure on systems running Red Hat Enterprise Linux 6
To upgrade
Command | Configure (formerly Dell Client Configuration Toolkit) version
2.2.1 to Command | Configure 3.0 on Red Hat Enterprise Linux 6 systems
using RPMs, browse to
lx64\RHEL6
directory,
untar the file, and run the commands in the following order:
- rpm -Uvh srvadmin-hapi-7.4.0-4.2.8.el6.x86_64.rpm
- rpm -Uvh command_configure-linux-3.0.0-<buildnum>.el6.x86_64.rpm
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\