- Notes, cautions, and warnings
- Introduction
- Installing Dell Command | Configure on systems running Microsoft Windows
- Installing Dell Command | Configure on systems running Linux
- Uninstalling Dell Command | Configure on systems running Microsoft Windows
- Uninstalling Dell Command | Configure on systems running Linux
- Upgrading Dell Command | Configure on systems running Microsoft Windows
- Upgrading Dell Command | Configure on systems running Linux
- Dell Command
| Configure for Microsoft Windows PE
- Creating a bootable
image preinstallation environment using Microsoft Windows PE 4.0,
5.0, and 10.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Microsoft Windows PE 10.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Microsoft Windows PE 5.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Microsoft Windows PE 4.0
- Creating a bootable image preinstallation environment using Microsoft Windows PE 2.0 and 3.0
- Creating a bootable
image preinstallation environment using Microsoft Windows PE 4.0,
5.0, and 10.0
- Reference
Dell Command | Configure Version 3.1.2 Installation Guide
Upgrading Dell Command | Configure on systems running Red Hat Enterprise Linux 6
To upgrade
Dell Command
| Configure
(formerly Dell Client Configuration Toolkit)
version 3.0 to
Dell Command
| Configure
3.1 on Red Hat Enterprise Linux 6 systems using RPMs, untar the
file, and run the commands in the following order:
- rpm -Uvh --nodeps srvadmin-hapi-8.2.0-1650.7979.el6.x86_64.rpm
- rpm -Uvh command_configure-linux-3.1.0-<buildnum>.el6.x86_64.rpm
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\