Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC OpenManage Enterprise Version 3.2 User's Guide

PDF

Deploy IOA templates

NOTE: To perform any tasks on OpenManage Enterprise, you must have necessary user privileges. See Role-based OpenManage Enterprise user privileges.

Before you begin deploying an IOA template, ensure that:
  • You have created an IOA deployment template for deployment. See Create a template from a reference device.
  • The target devices meet the requirements that are specified in Minimum system requirements for deploying OpenManange Enterprise.
  • Firmware version of the target device is the same as the IOA template.
  • Only the following cross template deployments are supported:
    Table 1. Supported cross template deploymentsThe following table lists the supported cross template deployments.
    IOA Deployment template modeSupported IOA template modes of target
    StandaloneStandalone, PMUX
    PMUX (Programmable MUX)PMUX, Standalone
    VLTVLT

CAUTION: Ensure that only the appropriate devices are selected for deployment. After deploying a configuration template on a repurpose and bare-metal device, it might not be possible to revert the device to its original configuration.

  1. From the list of templates on the Configuration > Deploy page, select the check box corresponding to the IOA template you want to deploy, and click Deploy Template.
  2. In the Deploy Template: <template_name> dialog box, under Target:
    1. Click Select, and then select device(s) in the Job Target dialog box. See Selecting target devices and device groups.
    2. Click OK.
  3. In the Host Names dialog box, you can change the Host name of the target IOA device. Click Next.
  4. In the Advanced Options dialog box, select Preview Mode to simulate the deployment or select Continue On Warning to deploy the template and ignore the warnings encountered. Click Next.
  5. In the Schedule section, run the job immediately or schedule for a later time. See Schedule job field definitions.
  6. Click Finish. Review the Warning message and click YES.
    A Device Configuration job is created under Jobs. See Using jobs for device control.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\