Dell EMC OpenManage Enterprise 3.9 User's Guide

Create a Remote command job for managing devices

Running
Verifying if the device Service Tag is valid.
The device Service Tag could not be verified.
Task Failed. Completed With Errors.
Please check the system to ensure the IP address has not changed since the last discovery was completed. Remediate by discovering the system with the updated IP address, and retrying the operation.

1. Click Create, and then select Remote Command on Devices.
2. In the Command Line Job Wizard dialog box, in the Options section:
   1. Enter the job name in Job Name.
   2. From the Interface drop-down menu, select one of the interfaces depending on the target devices you want to manage:
      • IPMI CLI — for iDRACs and non-Dell servers.
      • RACADM CLI — for iDRACs discovered using the WSMAN protocol.
      • SSH CLI — for Linux servers discovered using the SSH protocol.
   3. In the Arguments box, enter the command. Up to 100 commands can be typed with each command required to be on a new line.
      NOTE The commands in the Arguments box are run one at a time.
   4. Click Next.
      A green tick mark next to Options indicates that the necessary data is provided.
3. In the Target section, select the target devices and click Next. See Select target devices and device groups.
4. In the Schedule section, run the job immediately or schedule for a later time. See Schedule job field definitions.
5. Click Finish.
   The job is created and listed in the Jobs list and identified by an appropriate status in the JOB STATUS column.
6. If the job is scheduled for a later point, but you want to run the job immediately:
   • On the Jobs page, select the check box corresponding to the Scheduled job.
   • Click Run Now. The job is run and the status is updated.
   • To view the job data, click View Details in the right pane. See View an individual job information.