Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

advertise dcbx-appln-tlv

On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to DCBX peers.

Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}

To remove the application priority TLVs, use the no advertise dcbx-appln-tlv {fcoe | iscsi} command.

Parameters
{fcoe | iscsi}
Enter the application priority TLVs, where:
  • fcoe: enables the advertisement of FCoE in application priority TLVs.
  • iscsi: enables the advertisement of iSCSI in application priority TLVs.
Defaults
Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command Modes
PROTOCOL LLDP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To disable TLV transmission, use the no form of the command; for example, no advertise dcbx-appln-tlv iscsi.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\