Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

vrf vrf-name

(OPTIONAL) Enter the keyword vrf and then the name of the VRF to clear information on route dampening corresponding to that VRF

NOTE You can use this attribute on a specific VRF to remove history routes corresponding to that VRF. You can also use this attribute to return the suppressed routes corresponding to a specific VRF to an active state.

ipv4 multicast

(OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to clear the ipv4 multicast routes.

ipv4 unicast

(OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to clear the ipv4 unicast routes.

ipv6 unicast

(OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to clear the ipv6 unicast routes.

ipv4-address mask

(OPTIONAL) Enter an IPv4 address in dotted decimal format and the prefix mask in slash format (/x) to clear dampening information only that BGP neighbor.

ipv6–address mask

(OPTIONAL) Enter the IPv6 address and the network mask to clear information on IPv6 route dampening.

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.0)

Introduced on the S6100-ON.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100–ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Added the ipv4 multicast and ipv6 unicast parameters.

9.4.(0.0)

Added support for VRF.

9.2(1.0)

Introduced on the Z9500.

9.0.2.0

Introduced on the S6000.

8.3.19.0

Introduced on the S4820T.

8.3.11.1

Introduced on the Z9000.

8.3.7.0

Introduced on the S4810.

7.8.1.0

Introduced on the S-Series.

7.7.1.0

Introduced on the C-Series.

The clear ip bgp dampening command does not clear the history paths.