Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

dcb-map stack-unit all stack-ports all

Apply the specified DCB map on all ports of the switch stack.

Syntax
dcb-map stack-unit all stack-ports all dcb-map-name

To remove the PFC and ETS settings in a DCB map from all stack units, use the no dcb-map stack-unit all stack-ports all command.

Parameters
dcb-map-name
Enter the name of the DCB map.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.3(0.0)
Introduced on the S4810 and S6000 platforms.
Usage Information
The dcb-map stack-unit all stack-ports all command overwrites any previous DCB maps applied to stack ports.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\