Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

slot/port

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.0)

Introduced on the S6100–ON.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100–ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Introduced on the S6000-ON.

9.2(1.0)

Introduced on the Z9500.

9.0.2.0

Introduced on the S6000.

8.3.19.0

Introduced on the S4820T.

8.3.11.1

Introduced on the Z9000.

8.3.11.1

Introduced on the S55, S60, and S4810.

8.1.1.0

Introduced on the E-Series.

7.5.1.0

Introduced on the C-Series.

6.4.1.0

Introduced

You cannot delete a Management port.

The Management port is enabled by default (no shutdown). To assign an IP address to the Management port, use the ip address command.

DellEMC(conf)# interface managementethernet 1/1
DellEMC(conf-if-ma-1/1)#

• management route — configure a static route that points to the Management interface or a forwarding router.
• speed (Management interface) — Set the speed for the Management interface.