Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

To disable the address autoconfig operation on the management interface, use the no ipv6 address autoconfig command.

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.1.(0.0)

Updated Usage Information section.

8.3.19.0

Introduced on the S4820T.

8.3.12.0

Introduced on the S4810.

• SAA can configure up to two addresses. If any preferred prefix or valid timers time out, the corresponding address are deprecated or removed. If an address is removed due to a time-out, an address from the current unused prefix is used to create a new address. If there are no remaining prefixes, the software waits to receive a new prefix from the RA.

• If auto-configuration is enabled, all IPv6 addresses on that management interface are auto-configured. Manual and auto-configurations are not supported on a single management interface.

• Removing auto-configuration removes all auto-configured IPv6 addresses and the link-local IPv6 address from that management interface.

• IPv6 addresses on a single management interface cannot be members of the same subnet.

• IPv6 secondary addresses on management interfaces across a platform must be members of the same subnet.

• IPv6 secondary addresses on management interfaces should not match the virtual IP address and should not be in the same subnet as the virtual IP.