Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

ipv6 pim bsr-candidate

To join the Bootstrap election process, configure the PIM router as a bsr-candidate.

Syntax
ipv6 pim [vrf vrf-name] bsr-candidate interface [hash-mask-length] [priority]

To return to the default value, use the no ipv6 pim bsr-candidate [vrf vrf-name] command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf then the name of the VRF to configure the PIM router on a VRF.
interface
Enter the following keywords and slot/port or number information:
  • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
  • For a Port Channel interface, enter the keywords port-channel then a number.
  • For a VLAN, enter the keyword vlan then a number from 1 to 4094.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
hash-mask-length
(OPTIONAL) Enter the hash mask length. The range is from eight (8) to 128. The default is 126.
priority
(OPTIONAL) Enter the priority used in Bootstrap election process. The range is from zero (0) to 255. In the BSR election process, the BSR with the higher priority takes the precedence. If the priority values are equal, the router with the higher IP address becomes the BSR. The default is 0.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(1.0)
Introduced on the C9010, S3048-ON, S3100 Series, S4048-ON, S4048T-ON, S6000-ON, S6010-ON, S6100-ON, Z9100-ON.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\