Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

To disable sending a COMMUNITY attribute, use the no neighbor {ip-address | peer-group-name} send-community command.

ip-address

Enter the IP address of the peer router in dotted decimal format.

peer-group-name

Enter the name of the peer group to send a COMMUNITY attribute to all routers within the peer group.

extended

(OPTIONAL) Enter the keyword extended to send extended community attribute.

standard

(OPTIONAL) Enter the keyword standard to send standard community attribute.

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.0)

Introduced on the S6100-ON.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100–ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Introduced on the S6000–ON.

9.2(1.0)

Introduced on the Z9500.

Version 9.0.2.0

Introduced on the S6000.

8.3.11.1

Introduced on the Z9000.

7.8.1.0

Introduced on the S-Series.

7.7.1.0

Introduced on the C-Series.

In order that settings corresponding to the neighbor send-community command take effect, you must execute the clear ip bgp command immediately after you execute the neighbor send-community command.

If you do not set any of the optional parameters (standard or extended), then both standard as well as extended attributes are sent. If you set either the standard or extended parameter, only the attribute that is specified is sent.