Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

redundancy primary

Set an RPM as the primary RPM.

Syntax
redundancy primary [rpm0 | rpm1]

To delete a configuration, use the no redundancy primary command.

Parameters
rpm0
Enter the keyword rpm0 to set the RPM in slot R0 as the primary RPM.
rpm1
Enter the keyword rpm1 to set the RPM in slot R1 as the primary RPM.
Default
The RPM in slot R0 is the Primary RPM.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant DellEMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.5.1.0
Introduced on the C-Series.
7.6.1.0
Introduced on the E-Series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\