Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

router rip

To configure and enable RIP, enter ROUTER RIP mode.

Syntax
router rip

To disable RIP, use the no router rip command.

Defaults
Disabled.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
pre- 6.2.1.1
Introduced on the E-Series.
Usage Information
To enable RIP, assign a network address using the network command.
Example
DellEMC(conf)# router rip
DellEMC(conf-router_rip)#
Related Commands
  • network — enables RIP.
  • exit — returns to CONFIGURATION mode.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\