Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

set metric

To assign a new metric to redistributed routes, configure a filter.

Syntax
set metric [+ | -] metric-value

To delete a setting, enter no set metric.

Parameters
+
(OPTIONAL) Enter + to add a metric-value to the redistributed routes.
-
(OPTIONAL) Enter - to subtract a metric-value from the redistributed routes.
metric-value
Enter a number as the new metric value. The range is from zero (0) to 4294967295.
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
pre-6.1.1.0
Introduced on the E-Series.
Related Commands
  • set automatic-tag — compute the tag value of the route.
  • set level — specify the OSPF area for route redistribution.
  • set metric-type — specify the route type assigned to redistributed routes.
  • set tag — specify the tag assigned to redistributed routes.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\