Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

virtual-ip

Configure a virtual IP address for the active management interface. You can configure virtual addresses both for IPv4 and IPv6 independently.

Syntax
virtual-ip {ipv4-address | ipv6-address}

To return to the default, use the no virtual-ip {ipv4-address | ipv6-address} command.

Parameters
ipv4-address
Enter the IP address of the active management interface in a dotted decimal format (A.B.C.D.).
ipv6-address
Enter an IPv6 address of the active management interface, in the x:x:x:x::x format.
NOTE The :: notation specifies successive hexadecimal fields of zeros.
Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.5.1.0
Introduced on the C-Series.
E-Series
Original command.
Usage Information
You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time this command is issued, it replaces the previously configured address of the same family, IPv4 or IPv6. The no virtual-ip command takes an address/prefix-length argument, so that the desired address only is removed. If you enter the no virtual-ip command without any specified address, then both IPv4 and IPv6 virtual addresses are removed.
Related Commands
  • ip address — assigns a primary and secondary IP address to the interface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\