Dell Command Line Reference Guide for the S4048–ON System 9.14.2.6

To return to the default value, use the no ipv6 pim [vrf vrf-name] rp-candidate {interface [priority]} command.

vrf vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of the VRF.

NOTE Applies to specific VRF if input is provided, else applies to Default VRF.

interface

Enter the following keywords and slot/port or number information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For a port-channel interface, enter the keywords port-channel then the port-channel ID.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.

priority

(OPTIONAL) Enter the priority used in RP election process. The range is zero (0) to 255. The default is 192. In the RP election process, the RP with the lower priority takes the precedence.

acl-name

(OPTIONAL) Enter the name of an ACL to configure a PIM router to act as an RP for a specific set of multicast group addresses that are defined in the ACL.

NOTE If you do not specify the acl-name, the system uses the default multicast IPv6 group range, which is ff00::/8.

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.14(1.0)

Introduced on the C9010, S3048–ON, S3100 Series, S4048–ON, S4048T–ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON.