Dell Command Line Reference Guide for the S4048–ON System 9.14.2.6

S4048–ON

Syntax

show ip pim [vrf vrf-name] interface

Parameters

vrf vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this setting on this VRF.

NOTE Applies to specific VRF if input is provided, else applies to Default VRF.

Command Modes

• EXEC
• EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.0)

Introduced on the S6100-ON.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100-ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Added support for VRF. Introduced on the S6000-ON.

9.5(0.1)

Introduced on the Z9500.

9.0.2.0

Introduced on the S6000.

8.3.19.0

Introduced on the S4820T.

8.3.12.0

Introduced on the S4810.

8.3.11.1

Introduced on the Z9000.

8.1.1.0

Introduced on the E-Series.

7.8.1.0

Introduced on the S-Series.

Usage Information

The following describes the show ip pim interface command shown in the following example.

Field

Description

Address

Lists the IP addresses of the interfaces participating in PIM.

Interface

List the interface type, with either slot/port information or ID (VLAN or Port Channel), of the interfaces participating in PIM.

Ver/Mode

Displays the PIM version number and mode for each interface participating in PIM:

• v2 = PIM version 2
• S = PIM Sparse mode

Nbr Count

Displays the number of PIM neighbors discovered over this interface.

Query Intvl

Displays the query interval for Router Query messages on that interface (configured with ip pim query-interval command).

DR Prio

Displays the Designated Router priority value configured on the interface (use the ip pim dr-priority command).

DR

Displays the IP address of the Designated Router for that interface.

The show ip pim interface command does not display information corresponding to the loop-back interfaces.

Example

DellEMC# show ip pim interface
Address          Interface Ver/   Nbr    Query  DR       DR
                           Mode   Count  Intvl  Prio
165.87.34.5      Te 1/10   v2/S   0      30     1        165.87.34.5
10.1.1.2         Vl 10     v2/S   1      30     1        10.1.1.2
20.1.1.5         Vl 20     v2/S   1      30     1        20.1.1.5
165.87.31.200    Vl 30     v2/S   1      30     1        165.87.31.201
DellEMC#