Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

lldp tlv-select dot1tlv

Enables or disables the dot.1 TLVs to transmit in LLDP packets.

Syntax
lldp tlv-select dot1tlv { port-vlan-id | link-aggregation | vlan-name}
Parameters
  • port-vlan-id — Enter the port VLAN ID.
  • link-aggregation — Enable the link aggregation TLV.
  • vlan-name — Configure dot1 TLVs to send and receive the names of VLANs in LLDP frames.
Default
Enabled. vlan-name is disabled.
Command Mode
INTERFACE
Usage Information

The link-aggregation parameter advertises link aggregation as a dot1 TLV in the LLDPDUs.

The vlan-name parameter advertises the names of VLANs in LLDP frames.

The no version of this command disables TLV transmissions.

Example (Port) 
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv port-vlan-id
Example (Link Aggregation) 
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Example (VLAN name) 
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv vlan-name
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\