Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 11 3000 Service Manual

PDF

Procedure

  • CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.
  1. Place the display assembly on the palmrest and keyboard assembly.
  2. Align the screw holes on the display hinges with the screw holes on the palmrest and keyboard assembly.
  3. Replace the screws that secure the display assembly to the palmrest and keyboard assembly.
  4. Turn the computer over and close the display.
  5. Slide the I/O-board cable into its slot on the system board and press down the latch to secure the cable.
  6. Route the antenna cable through its routing on the right speaker.
  7. Slide the sensor-board cable into its slot on the I/O board and press down the latch to secure the cable.
  8. Slide the display cable into its slot on the system board and press down the latch to secure the cable.
  9. Adhere the tape on the display cable.
  10. Align the screw hole on the display-cable bracket with the screw hole on the system board.
  11. Replace the screw that secures the display-cable bracket to the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\