- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 15 5502
- Base cover
- Battery
- Memory module
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Wireless card
- Fan
- Coin-cell battery
- Heat sink
- Display assembly
- Power-adapter port
- Speakers
- Power button with optional fingerprint reader
- Touchpad
- I/O board
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 15 5502 Service Manual
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the installation procedure.
Steps
- Place the display assembly on a clean and flat surface.
- Align and slide the palm-rest and keyboard assembly under the display hinges.
NOTE To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
- Press down the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
- Replace the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the right display hinge to the system board.
- Replace the three screws (M2.5x5) that secure the left display hinge to the system board.
- Connect the display cable to the system board, close the latch, and adhere the tape that secures the display cable to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\