Inspiron 7591 2in1 Service Manual

Procedure

1. Place the display assembly on the palm-rest assembly. Align the screw holes on the display hinges with the screw holes on the I/O board and system board.
2. Replace the four screws (M2.5x4) that secure the display hinges to the I/O board and system board.
3. Close the display.
   
4. Connect the display cable to the system board .
5. Adhere the tape that secures the display cable to the system board.
6. Route the touchscreen-board cable through the routing guides on the palm-rest assembly, and adhere the tape that secures the touchscreen-board cable to the palm-rest assembly.
7. Slide the touchscreen-board cable into the connector on the system board and close the latch to secure the cable.