- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the memory module
- Replacing the memory module
- Removing the base cover
- Replacing the base cover
- Removing the mSATA card
- Replacing the mSATA card
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the wireless card
- Replacing the wireless card
- Removing the computer base
- Replacing the computer base
- Removing the hard drive
- Replacing the hard drive
- Removing the speakers
- Replacing the speakers
- Removing the USB board
- Replacing the USB board
- Removing the fan
- Replacing the fan
- Removing the heat sink
- Replacing the heat sink
- Removing the system board
- Replacing the system board
- Removing the back cover
- Replacing the back cover
- Removing the camera
- Replacing the camera
- Removing the microphone
- Replacing the microphone
- Removing the converter board
- Replacing the converter board
- Removing the power-button module
- Replacing the power-button module
- Removing the stand assembly
- Replacing the stand assembly
- Removing the display panel
- Replacing the display panel
- Removing the control-buttons board
- Replacing the control-buttons board
- Clearing forgotten passwords
- Clearing CMOS settings
- Flashing the BIOS
- Getting help and contacting Dell
Inspiron 247000 Series Service Manual
Procedure
- Align the screw hole on the USB board with the screw hole on the computer base.
- Replace the screw that secures the USB board to the computer base.
- Connect the USB-board cable to the USB board.
- Route the USB-board cable through the routing clip on the computer base and close the routing clip.
- Adhere the tape over the USB-board cable.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\