- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the back cover
- Replacing the back cover
- Removing the stand
- Replacing the stand
- Removing the hard drive
- Replacing the hard drive
- Removing the inner frame
- Replacing the inner frame
- Removing the camera
- Replacing the camera
- Removing the microphones
- Replacing the microphones
- Removing the power-button board
- Replacing the power-button board
- Removing the front bezel
- Replacing the front bezel
- Removing the media-card reader
- Replacing the media-card reader
- Removing the side I/O-board
- Replacing the side I/O-board
- Removing the system-board shield
- Replacing the system-board shield
- Removing the fan
- Replacing the fan
- Removing the speakers
- Replacing the speakers
- Removing the subwoofer
- Replacing the subwoofer
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the heat sink
- Replacing the heat sink
- Removing the processor
- Replacing the processor
- Removing the I/O bracket
- Replacing the I/O bracket
- Removing the I/O board
- Replacing the I/O board
- Removing the system board
- Replacing the system board
- Removing the middle frame
- Replacing the middle frame
- Removing the display panel
- Replacing the display panel
- Flashing the BIOS
- BIOS setup program
- Diagnostics
- Getting help and contacting Dell
Inspiron 27 7000 Service Manual
Procedure
- Align the screw holes on the system board with the screw holes on the middle frame.
- Replace the five screws (M3x5) that secure the system board to the middle frame.
- Connect the microphone cable (DMIC1), camera cable (WEBCAM), side I/O-board cable (MB-SUSBC), media-card reader cable (SDRDC1), speaker cable (SPEAKER), subwoofer cable (WOOFC1), I/O-board power cable (RPWRC1), I/O-board cable (LAUOC1), USB Type-C cable (MB-TYPEC1), hard-drive power cable (SATA_PWR1), and I/O cable (RUSBC1) to their respective connectors on the system board.
- Connect the hard-drive data cable (SATA0), power cable (MB-DCPWR), power-button board cable (0SDC1), display cable (MB-DISPC) and fan-power cable (FAN_SYS) to their respective connectors on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\