- Notes, cautions, and warnings
- Working inside your computer
- Recommended tools
- Screw list
- Inside view of your computer
- System-board components
- Removing the computer cover
- Replacing the computer cover
- Removing the front bezel
- Replacing the front bezel
- Removing the memory module
- Replacing the memory module
- Removing the solid-state drive/Intel Optane
- Replacing the solid-state drive/Intel Optane
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the wireless card
- Replacing the wireless card
- Removing the power-supply unit
- Replacing the power-supply unit
- Removing the 3.5-inch hard drive
- Replacing the 3.5-inch hard drive
- Removing the 2.5-inch hard drive
- Replacing the 2.5-inch hard drive
- Removing the optical drive
- Replacing the optical drive
- Removing the graphics card
- Replacing the graphics card
- Removing the processor fan and heat-sink assembly
- Replacing the processor fan and heat-sink assembly
- Removing the processor
- Replacing the processor
- Removing the antenna modules
- Replacing the antenna modules
- Removing the system board
- Replacing the system board
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 3671 Service Manual
Procedure
- Locate the password jumper (PSWD) on the system
board.
NOTE: : For more information on the location of the jumper, see “System-board components”.
- Remove the jumper plug from the password jumper-pins.
- Wait for 5 seconds and then replace the jumper
plug in its original location.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\