Latitude 7390 2-in-1 Owner's Manual

Installing the display assembly

1. Place the base of the computer on a flat surface.
2. Align the display assembly with the display hinge screw holders.
3. Replace the 4 (M2.5 x 4.0) screws to secure the display assembly.
4. Close the display assembly and flip the computer.
5. Connect the cables:
   1. G-sensor and eDP cable
   2. Place the eDP bracket on the eDP cable and replace the 2 (M2 x 2) screw on the bracket.
   3. IR camera and touch screen cables
6. Route the antenna cables through the routing clips
7. Affix the tapes to secure the antenna cables to the system board.
8. Install the:
   1. WWAN card
   2. WLAN card
   3. Battery
   4. Base cover
   5. SIM card tray
   6. MicroSD card

      NOTE: : To install both cards if equipped.

9. Follow the procedure in After working inside your computer.