Latitude 7390 2-in-1 Owner's Manual

Removing the display assembly

1. Follow the procedure in Before working inside your computer.
2. Remove the:
   1. Micro SD
   2. SIM card tray

      NOTE: : Remove both the cards if equipped and no need to remove the blank filler

   3. Base cover
   4. Battery
   5. WLAN card
   6. WWAN card
3. Peel the tapes that secure the antenna cables to the system board and remove the cables from the routing clips.
   
4. Disconnect the :
   1. IR camera and touchscreen cable [1].
   2. Remove the 2 (M 2 x 1.7L) screws that secure the eDP bracket and lift it away from the computer [2].
   3. Disconnect the eDP cable from the system board [3].
   4. Disconnect the G-sensor and eDP cables [4].
   
5. Lift the base of the computer away from the display assembly.
   
6. To remove the display assembly:
   1. Place the base of the computer with the display assembly.

      NOTE: : Open LCD as shown in the illustration

   2. Remove the 4 (M2.5 x 4.0) screws that secure the display hinge brackets [1].
   3. Lift the display assembly away from the computer [2].