Latitude 7490 Owner's Manual

Installing the display panel (nontouch)

1. Connect the display cable on the back of the display panel.
   NOTE For Latitude 7490, the LED daughter board cable must be routed underneath the securing latch on the palm-rest, and the label should be placed underneath the system board.
2. Affix the mylar tape securing the display cable on the back of the display panel.
3. Affix display connector adhesive strip to the display panel.
4. Flip the display panel over and slide the display panel towards the system.
5. Replace the two (M2.0 x 2.0) screws on the panel.
6. Install the bezel.
7. Install the hinge cap.
8. Install the display assembly.
9. Install the WLAN card.
10. Install the WWAN card.
11. Connect the battery cable to the connector on the system board.
12. Install the base cover.
13. Follow the procedure in After working inside your computer.