Create customized device discovery job protocol for SNMP devices
About this task
By default, the
Discover using SNMP check box is selected to enable you detect the storage, networking, or other SNMP devices.
NOTE Only the IO Modules with Standalone, PMUX (Programmable MUX), VLT (Virtual Link Trunking) Modes are discoverable. Full switch and Stacked Modes will not be discovered.
Steps
Under
Credentials, select the SNMP version, and then enter the community type.
In the
Connection Settings section:
In the
Retries box, enter the number of repeated attempts that must be made to discover a server.
In the
Timeout box, enter the time after which a job must stop running.
In the
Port box, enter the port number that the job must use to discover.
NOTE The settings in the
Retries box and the
Timeout box do not have any functional impact on the discovery jobs for SNMP devices. Hence, these settings can be ignored.
Click
Finish.
Complete the tasks in
Creating a device discovery job. For more information, see OpenManage Enterprise User's Guide.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\