The warranty
retrieval job configuration is available from the Settings tab in
OMIVV. In addition, you can also run or schedule warranty retrieval
job from Job Queue > Warranty. The scheduled jobs are listed in the job queue. In
an SSO environment with multiple vCenter servers, the chassis warranty
runs automatically with every vCenter when the warranty for any vCenter
is run. However, warranty does not automatically run if it is not
added to chassis profile.
NOTE The settings in this
page are reset to default each time the configuration wizard is invoked.
If you have previously configured a warranty retrieval job, ensure
that you replicate that schedule warranty retrieval job in this page
before completing the wizard functions so that the previous warranty
retrieval is not overridden by the default settings.
Steps
In the Warranty Schedule dialog box, select Enable Warranty Data Retrieval.
In Warranty Data Retrieval Schedule, do the
following:
Select the check box next to each day of the week that you want
to run the warranty.
Enter the time in HH:MM format.
The time you enter is your local time. Therefore,
if you want to run the inventory at the virtual appliance time zone,
calculate the time difference between your local and virtual appliance
time zone, and then enter the time appropriately.
To apply the changes and continue, click Next, and then proceed with the Event and Alarm settings.
Once you click next, all details that you
provide in this wizard is saved and you cannot modify the details
from the wizard. You can modify warranty job schedules from the Settings tab after completing the configuration from
the configuration wizard. See Modifying
warranty job schedules in the OpenManage
Integration for VMware vCenter User’s Guide at Dell.com/support/manuals.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\