Dell EMC OpenManage Plug-in Version 3.0 for Nagios Core Release Notes

Issue 1(25122):

In "Dell EMC Chassis I/O Module Status" service, value for "FabricType" is shown incorrectly as "UNKNOWN, for few IO Modules when PowerEdge M1000e chassis is discovered.

Dell EMC OpenManage Plug-in Version 3.0 for Nagios XI.

Issue 2(25121):

In "Dell EMC Chassis power supply status" service, health status for one of the power supply instance which is standby is shown as "UNKNOWN" when Dell EMC Chassis is discovered.

Dell EMC OpenManage Plug-in Version 3.0 for Nagios XI.

Issue 3(92913):

In "Dell EMC Network Switch Physical Port Status" service may get timed out in case high number of vlan/virtual ports are configured under monitored Dell EMC Network device.

Dell EMC OpenManage Plug-in Version 3.0 for Nagios XI.

Launch the respective chassis console for the PowerEdge M1000e, PowerEdge VRTX, and PowerEdge FX2/FX2s chassis host from the Nagios XI to view the the health status of standby power supply.

Issue 4(93599):

In "Dell EMC Server Controller Status" service, an extra instance will be shown only when Dell EMC PowerEdge server is been discovered using RedFish protocol and that device have SATA controller.

Dell EMC OpenManage Plug-in Version 3.0 for Nagios XI.

Launch the respective device console for the Dell EMC PowerEdge Server from Nagios XI to view the actual controller instance.

Issue 5 (255091):

In "Dell EMC Server Overall Health Status" service, Power Supply Status is shown as OK instead of UNKNOWN when DSS 1510 device is discovered using SNMP and WSMan protocol.

Dell EMC OpenManage Plug-in Version 3.0 for Nagios XI.

Issue 6(98517):

Discovery of Dell EMC PowerEdge 14G server (Rack and Cloud) with firmware versions between 3.00.00.00 and 3.15.15.15 using IPv6 with WSMan or RedFish protocol will fail.

Dell EMC OpenManage Plug-in Version 3.0 for Nagios XI.