The requirements for the managed systems are
as follows:
Table 1. Supported firmware
versions for Dell EMC devicesThis table lists the supported firmware versions
for the supported Dell EMC devices.
Dell EMC Device
Firmware
Supported Firmware Versions
12th generation of PowerEdge servers
iDRAC7
2.41.40.40 and 2.40.40.40
13th generation of PowerEdge servers
iDRAC8
2.41.40.40 and 2.40.40.40
14th generation of PowerEdge servers
iDRAC9
3.00.00.00
Datacenter Scalable Solutions
iDRAC8
2.41.40.40 and 2.40.40.40
HCI Platforms
iDRAC8
2.41.40.40 and 2.40.40.40
PowerEdge M1000e Chassis
CMC
5.22 and 5.21
PowerEdge VRTX Chassis
CMC
2.23 and 2.22
PowerEdge FX2/FX2s Chassis
CMC
1.42 and 1.41
Compellent Storage Arrays
NA
7.1.12 and 6.7.40
EqualLogic PS-Series Storage Arrays
NA
9.1.2 and 9.1.1
PowerVault MD 34/38 Series Storage Arrays
NA
08.25.11.60 and 08.25.09.61
If you are using SNMP, ensure that SNMP is configured
in the respective devices.
If you want to receive
SNMP traps in the Nagios Core console, ensure that you configure the
SNMP trap destination in the respective devices.
For more information,
see Appendix in the Dell EMC OpenManage Plug-in Version 2.1
for Nagios Core User’s Guide at dell.com/omconnectionsEnterpriseSystemsManagement.
If you are using WSMan protocol, it is recommended
that you use a WSMan service account other than the default service
account. For more information, see Configuring User Accounts and
Privileges in the respective device’s User’s Guide at Dell.com/esmmanuals.
For the list of supported platforms, see Support
Matrix in the Dell EMC OpenManage Plug-in Version 2.1 for Nagios
Core User’s Guide.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\